GloveGun

by Corza

--------------------------------------------------------------------------------
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
--------------------------------------------------------------------------------

GloveGun

Materials:

Small metal Rubber glove fingers Duct tape

Optional: Welder

Step one:

Cut the finger of one ruber glove right down near the base. Get some pipe and make sure its just big enough so that you can strech the glove over it and it stays on.

Step two:

Cut the pipe to about 35 cm and 10 cm for a handle.

Step three:

Cut the end of the handle bit at 45 degrees, then weld it at the very end of the 35cm peice so it is in the shape of a number 7.

Step four:

Duct tape the handle up, and file of any cut ends. Then duct tape a glove finger about 3cms on the end of the pipe.

How to use:

Use fishing sinkers, ball bearings or my prefered ammo, metal nuts about one cm across. You can experiment with ammo and by putting a laser pointer on top but do not use rocks cause they cut up the glove fingers